+/EE445L

embedded systems

git clone https://git.julia.blue/+/EE445L

Joseph RyanAdd other starter filesc12dcba

master
2.7 KiB90 linesraw
1// LED.h
2// Runs on TM4C123
3// Provide functions that initialize a GPIO as an input pin and
4// allow reading of two negative logic switches on PF0 and PF4
5
6// Use bit-banded I/O.
7// Daniel and Jonathan Valvano
8// Feb 23, 2015
9
10/* This example accompanies the book
11   "Embedded Systems: Introduction to ARM Cortex M Microcontrollers",
12   ISBN: 978-1469998749, Jonathan Valvano, copyright (c) 2014
13   Section 4.2    Program 4.2
14
15  "Embedded Systems: Real Time Interfacing to ARM Cortex M Microcontrollers",
16   ISBN: 978-1463590154, Jonathan Valvano, copyright (c) 2014
17   Example 2.3, Program 2.9, Figure 2.36
18
19 Copyright 2015 by Jonathan W. Valvano, valvano@mail.utexas.edu
20    You may use, edit, run or distribute this file
21    as long as the above copyright notice remains
22 THIS SOFTWARE IS PROVIDED "AS IS".  NO WARRANTIES, WHETHER EXPRESS, IMPLIED
23 OR STATUTORY, INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRANTIES OF
24 MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE APPLY TO THIS SOFTWARE.
25 VALVANO SHALL NOT, IN ANY CIRCUMSTANCES, BE LIABLE FOR SPECIAL, INCIDENTAL,
26 OR CONSEQUENTIAL DAMAGES, FOR ANY REASON WHATSOEVER.
27 For more information about my classes, my research, and my books, see
28 http://users.ece.utexas.edu/~valvano/
29 */
30#include <stdint.h>
31
32//------------LED_Init------------
33// Initialize GPIO Port F for negative logic switches on PF0 and
34// PF4 as the Launchpad is wired.  Weak internal pull-up
35// resistors are enabled, and the NMI functionality on PF0 is disabled.
36// LEDs on PF3,2,1 are enabled
37// Input: none
38// Output: none
39void LED_Init(void);
40
41//------------Board_Input------------
42// Read and return the status of the switches.
43// Input: none
44// Output: 2 if only Switch 1 is pressed
45//         1 if only Switch 2 is pressed
46//         3 if both switches are pressed
47//         0 if no switches are pressed
48uint32_t Board_Input(void);
49
50//------------LED_RedOn------------
51// Turn on red LED
52// Input: none
53// Output: none
54void LED_RedOn(void);
55
56//------------LED_RedOff------------
57// Turn off red LED
58// Input: none
59// Output: none
60void LED_RedOff(void);
61
62//------------LED_RedToggle------------
63// Toggle redv LED
64// Input: none
65// Output: none
66void LED_RedToggle(void);
67
68//------------LED_BlueToggle------------
69// Toggle blue LED
70// Input: none
71// Output: none
72void LED_BlueToggle(void);
73
74//------------LED_GreenToggle------------
75// Toggle green LED
76// Input: none
77// Output: none
78void LED_GreenToggle(void);
79
80//------------LED_GreenOn------------
81// Turn on green LED
82// Input: none
83// Output: none
84void LED_GreenOn(void);
85
86//------------LED_GreenOff------------
87// Turn off green LED
88// Input: none
89// Output: none
90void LED_GreenOff(void);