-- Kirby's Airride (NTSC-J v1.0) local core = require("games.core") local game = core.newGame() local addr = 0x80585B64 local off = 0x44 local controllers = { [1] = addr + off * 0, [2] = addr + off * 1, [3] = addr + off * 2, [4] = addr + off * 3, } -- Notably similar addresses to Melee, which makes sense since both games are made by HAL. local controller_struct = { [0x00] = { type = "int", name = "controller.%d.buttons.pressed" }, [0x20] = { type = "float", name = "controller.%d.joystick.x" }, [0x24] = { type = "float", name = "controller.%d.joystick.y" }, [0x28] = { type = "float", name = "controller.%d.cstick.x" }, [0x2C] = { type = "float", name = "controller.%d.cstick.y" }, [0x30] = { type = "float", name = "controller.%d.analog.l" }, [0x34] = { type = "float", name = "controller.%d.analog.r" }, [0x41] = { type = "byte", name = "controller.%d.plugged" }, -- A note about plugged: -- Byte 0x41 of each controller is set from 0x00 to 0x01 only after the -- controller has been plugged in or the game was started with the -- controller plugged in, however, the overlay does not seem to -- detect this behavior, therefore showing all controllers regardless -- of memory status as unplugged. -- Melee has a similar issue, but instead of setting byte 0x41 to 0x01, -- it starts as 0xFF and gets set to 0x00. -- I've fixed this issue by detecting whether or not the current game is -- Kirby Air Ride and changing the number to compare against from 0x00 to -- 0x01 for Kirby Air Ride only. } for port, address in ipairs(controllers) do for offset, info in pairs(controller_struct) do game.memorymap[address + offset] = { type = info.type, debug = info.debug, name = info.name:format(port), } end end game.translateJoyStick = function(x, y) return x, y end game.translateCStick = function(x, y) return x, y end game.translateTriggers = function(l, r) return l, r end game.pluggedValue = 0x01 -- value the game sets the controller.plugged byte to return game