fork/rust
git clone https://git.julia.blue/fork/rust
4560ea788cb
1.39.0
1/* This symbol is used at runtime to figure out the virtual address that the */ 2/* enclave is loaded at. */ 3.section absolute 4.global IMAGE_BASE 5IMAGE_BASE: 6 7.section ".note.x86_64-fortanix-unknown-sgx", "", @note 8 .align 4 9 .long 1f - 0f /* name length (not including padding) */ 10 .long 3f - 2f /* desc length (not including padding) */ 11 .long 1 /* type = NT_VERSION */ 120: .asciz "toolchain-version" /* name */ 131: .align 4 142: .long 0 /* desc - toolchain version number, 32-bit LE */ 153: .align 4 16 17.section .rodata 18/* The XSAVE area needs to be a large chunk of readable memory, but since we are */ 19/* going to restore everything to its initial state (XSTATE_BV=0), only certain */ 20/* parts need to have a defined value. In particular: */ 21/* */ 22/* * MXCSR in the legacy area. This register is always restored if RFBM[1] or */ 23/* RFBM[2] is set, regardless of the value of XSTATE_BV */ 24/* * XSAVE header */ 25.align 64 26.Lxsave_clear: 27.org .+24 28.Lxsave_mxcsr: 29 .int 0 30 31/* We can store a bunch of data in the gap between MXCSR and the XSAVE header */ 32 33/* The following symbols point at read-only data that will be filled in by the */ 34/* post-linker. */ 35 36/* When using this macro, don't forget to adjust the linker version script! */ 37.macro globvar name:req size:req 38 .global \name 39 .protected \name 40 .align \size 41 .size \name , \size 42 \name : 43 .org .+\size 44.endm 45 /* The base address (relative to enclave start) of the heap area */ 46 globvar HEAP_BASE 8 47 /* The heap size in bytes */ 48 globvar HEAP_SIZE 8 49 /* Value of the RELA entry in the dynamic table */ 50 globvar RELA 8 51 /* Value of the RELACOUNT entry in the dynamic table */ 52 globvar RELACOUNT 8 53 /* The enclave size in bytes */ 54 globvar ENCLAVE_SIZE 8 55 /* The base address (relative to enclave start) of the enclave configuration area */ 56 globvar CFGDATA_BASE 8 57 /* Non-zero if debugging is enabled, zero otherwise */ 58 globvar DEBUG 1 59 /* The base address (relative to enclave start) of the enclave text section */ 60 globvar TEXT_BASE 8 61 /* The size in bytes of enclacve text section */ 62 globvar TEXT_SIZE 8 63 /* The base address (relative to enclave start) of the enclave EH_FRM_HDR section */ 64 globvar EH_FRM_HDR_BASE 8 65 /* The size in bytes of enclacve EH_FRM_HDR section */ 66 globvar EH_FRM_HDR_SIZE 8 67 68.org .Lxsave_clear+512 69.Lxsave_header: 70 .int 0, 0 /* XSTATE_BV */ 71 .int 0, 0 /* XCOMP_BV */ 72 .org .+48 /* reserved bits */ 73 74.data 75.Laborted: 76 .byte 0 77 78/* TCS local storage section */ 79.equ tcsls_tos, 0x00 /* initialized by loader to *offset* from image base to TOS */ 80.equ tcsls_flags, 0x08 /* initialized by loader */ 81.equ tcsls_flag_secondary, 0 /* initialized by loader; 0 = standard TCS, 1 = secondary TCS */ 82.equ tcsls_flag_init_once, 1 /* initialized by loader to 0 */ 83/* 14 unused bits */ 84.equ tcsls_user_fcw, 0x0a 85.equ tcsls_user_mxcsr, 0x0c 86.equ tcsls_last_rsp, 0x10 /* initialized by loader to 0 */ 87.equ tcsls_panic_last_rsp, 0x18 /* initialized by loader to 0 */ 88.equ tcsls_debug_panic_buf_ptr, 0x20 /* initialized by loader to 0 */ 89.equ tcsls_user_rsp, 0x28 90.equ tcsls_user_retip, 0x30 91.equ tcsls_user_rbp, 0x38 92.equ tcsls_user_r12, 0x40 93.equ tcsls_user_r13, 0x48 94.equ tcsls_user_r14, 0x50 95.equ tcsls_user_r15, 0x58 96.equ tcsls_tls_ptr, 0x60 97.equ tcsls_tcs_addr, 0x68 98 99.macro load_tcsls_flag_secondary_bool reg:req comments:vararg 100 .ifne tcsls_flag_secondary /* to convert to a bool, must be the first bit */ 101 .abort 102 .endif 103 mov $(1<<tcsls_flag_secondary),%e\reg 104 and %gs:tcsls_flags,%\reg 105.endm 106 107.text 108.global sgx_entry 109.type sgx_entry,function 110sgx_entry: 111/* save user registers */ 112 mov %rcx,%gs:tcsls_user_retip 113 mov %rsp,%gs:tcsls_user_rsp 114 mov %rbp,%gs:tcsls_user_rbp 115 mov %r12,%gs:tcsls_user_r12 116 mov %r13,%gs:tcsls_user_r13 117 mov %r14,%gs:tcsls_user_r14 118 mov %r15,%gs:tcsls_user_r15 119 mov %rbx,%gs:tcsls_tcs_addr 120 stmxcsr %gs:tcsls_user_mxcsr 121 fnstcw %gs:tcsls_user_fcw 122/* reset user state */ 123 cld /* x86-64 ABI requires DF to be unset at function entry/exit */ 124/* check for debug buffer pointer */ 125 testb $0xff,DEBUG(%rip) 126 jz .Lskip_debug_init 127 mov %r10,%gs:tcsls_debug_panic_buf_ptr 128.Lskip_debug_init: 129/* check for abort */ 130 bt $0,.Laborted(%rip) 131 jc .Lreentry_panic 132/* check if returning from usercall */ 133 mov %gs:tcsls_last_rsp,%r11 134 test %r11,%r11 135 jnz .Lusercall_ret 136/* setup stack */ 137 mov %gs:tcsls_tos,%rsp /* initially, RSP is not set to the correct value */ 138 /* here. This is fixed below under "adjust stack". */ 139/* check for thread init */ 140 bts $tcsls_flag_init_once,%gs:tcsls_flags 141 jc .Lskip_init 142/* adjust stack */ 143 lea IMAGE_BASE(%rip),%rax 144 add %rax,%rsp 145 mov %rsp,%gs:tcsls_tos 146/* call tcs_init */ 147/* store caller-saved registers in callee-saved registers */ 148 mov %rdi,%rbx 149 mov %rsi,%r12 150 mov %rdx,%r13 151 mov %r8,%r14 152 mov %r9,%r15 153 load_tcsls_flag_secondary_bool di /* RDI = tcs_init() argument: secondary: bool */ 154 call tcs_init 155/* reload caller-saved registers */ 156 mov %rbx,%rdi 157 mov %r12,%rsi 158 mov %r13,%rdx 159 mov %r14,%r8 160 mov %r15,%r9 161.Lskip_init: 162/* call into main entry point */ 163 load_tcsls_flag_secondary_bool cx /* RCX = entry() argument: secondary: bool */ 164 call entry /* RDI, RSI, RDX, R8, R9 passed in from userspace */ 165 mov %rax,%rsi /* RSI = return value */ 166 /* NOP: mov %rdx,%rdx */ /* RDX = return value */ 167 xor %rdi,%rdi /* RDI = normal exit */ 168.Lexit: 169/* clear general purpose register state */ 170 /* RAX overwritten by ENCLU */ 171 /* RBX set later */ 172 /* RCX overwritten by ENCLU */ 173 /* RDX contains return value */ 174 /* RSP set later */ 175 /* RBP set later */ 176 /* RDI contains exit mode */ 177 /* RSI contains return value */ 178 xor %r8,%r8 179 xor %r9,%r9 180 xor %r10,%r10 181 xor %r11,%r11 182 /* R12 ~ R15 set by sgx_exit */ 183.Lsgx_exit: 184/* clear extended register state */ 185 mov %rdx, %rcx /* save RDX */ 186 mov $-1, %rax 187 mov %rax, %rdx 188 xrstor .Lxsave_clear(%rip) 189 mov %rcx, %rdx /* restore RDX */ 190/* clear flags */ 191 pushq $0 192 popfq 193/* restore user registers */ 194 mov %gs:tcsls_user_r12,%r12 195 mov %gs:tcsls_user_r13,%r13 196 mov %gs:tcsls_user_r14,%r14 197 mov %gs:tcsls_user_r15,%r15 198 mov %gs:tcsls_user_retip,%rbx 199 mov %gs:tcsls_user_rsp,%rsp 200 mov %gs:tcsls_user_rbp,%rbp 201 fldcw %gs:tcsls_user_fcw 202 ldmxcsr %gs:tcsls_user_mxcsr 203/* exit enclave */ 204 mov $0x4,%eax /* EEXIT */ 205 enclu 206/* end sgx_entry */ 207 208.Lreentry_panic: 209 orq $8,%rsp 210 jmp abort_reentry 211 212/* This *MUST* be called with 6 parameters, otherwise register information */ 213/* might leak! */ 214.global usercall 215usercall: 216 test %rcx,%rcx /* check `abort` function argument */ 217 jnz .Lusercall_abort /* abort is set, jump to abort code (unlikely forward conditional) */ 218 jmp .Lusercall_save_state /* non-aborting usercall */ 219.Lusercall_abort: 220/* set aborted bit */ 221 movb $1,.Laborted(%rip) 222/* save registers in DEBUG mode, so that debugger can reconstruct the stack */ 223 testb $0xff,DEBUG(%rip) 224 jz .Lusercall_noreturn 225.Lusercall_save_state: 226/* save callee-saved state */ 227 push %r15 228 push %r14 229 push %r13 230 push %r12 231 push %rbp 232 push %rbx 233 sub $8, %rsp 234 fstcw 4(%rsp) 235 stmxcsr (%rsp) 236 movq %rsp,%gs:tcsls_last_rsp 237.Lusercall_noreturn: 238/* clear general purpose register state */ 239 /* RAX overwritten by ENCLU */ 240 /* RBX set by sgx_exit */ 241 /* RCX overwritten by ENCLU */ 242 /* RDX contains parameter */ 243 /* RSP set by sgx_exit */ 244 /* RBP set by sgx_exit */ 245 /* RDI contains parameter */ 246 /* RSI contains parameter */ 247 /* R8 contains parameter */ 248 /* R9 contains parameter */ 249 xor %r10,%r10 250 xor %r11,%r11 251 /* R12 ~ R15 set by sgx_exit */ 252/* extended registers/flags cleared by sgx_exit */ 253/* exit */ 254 jmp .Lsgx_exit 255.Lusercall_ret: 256 movq $0,%gs:tcsls_last_rsp 257/* restore callee-saved state, cf. "save" above */ 258 mov %r11,%rsp 259 ldmxcsr (%rsp) 260 fldcw 4(%rsp) 261 add $8, %rsp 262 pop %rbx 263 pop %rbp 264 pop %r12 265 pop %r13 266 pop %r14 267 pop %r15 268/* return */ 269 mov %rsi,%rax /* RAX = return value */ 270 /* NOP: mov %rdx,%rdx */ /* RDX = return value */ 271 ret 272 273/* 274The following functions need to be defined externally: 275``` 276// Called by entry code on re-entry after exit 277extern "C" fn abort_reentry() -> !; 278 279// Called once when a TCS is first entered 280extern "C" fn tcs_init(secondary: bool); 281 282// Standard TCS entrypoint 283extern "C" fn entry(p1: u64, p2: u64, p3: u64, secondary: bool, p4: u64, p5: u64) -> (u64, u64); 284``` 285*/ 286 287.global get_tcs_addr 288get_tcs_addr: 289 mov %gs:tcsls_tcs_addr,%rax 290 ret 291 292.global get_tls_ptr 293get_tls_ptr: 294 mov %gs:tcsls_tls_ptr,%rax 295 ret 296 297.global set_tls_ptr 298set_tls_ptr: 299 mov %rdi,%gs:tcsls_tls_ptr 300 ret 301 302.global take_debug_panic_buf_ptr 303take_debug_panic_buf_ptr: 304 xor %rax,%rax 305 xchg %gs:tcsls_debug_panic_buf_ptr,%rax 306 ret