fork/rust
git clone https://git.julia.blue/fork/rust
73528e339aa
1.40.0
1/* This symbol is used at runtime to figure out the virtual address that the */ 2/* enclave is loaded at. */ 3.section absolute 4.global IMAGE_BASE 5IMAGE_BASE: 6 7.section ".note.x86_64-fortanix-unknown-sgx", "", @note 8 .align 4 9 .long 1f - 0f /* name length (not including padding) */ 10 .long 3f - 2f /* desc length (not including padding) */ 11 .long 1 /* type = NT_VERSION */ 120: .asciz "toolchain-version" /* name */ 131: .align 4 142: .long 0 /* desc - toolchain version number, 32-bit LE */ 153: .align 4 16 17.section .rodata 18/* The XSAVE area needs to be a large chunk of readable memory, but since we are */ 19/* going to restore everything to its initial state (XSTATE_BV=0), only certain */ 20/* parts need to have a defined value. In particular: */ 21/* */ 22/* * MXCSR in the legacy area. This register is always restored if RFBM[1] or */ 23/* RFBM[2] is set, regardless of the value of XSTATE_BV */ 24/* * XSAVE header */ 25.align 64 26.Lxsave_clear: 27.org .+24 28.Lxsave_mxcsr: 29 .int 0 30 31/* We can store a bunch of data in the gap between MXCSR and the XSAVE header */ 32 33/* The following symbols point at read-only data that will be filled in by the */ 34/* post-linker. */ 35 36/* When using this macro, don't forget to adjust the linker version script! */ 37.macro globvar name:req size:req 38 .global \name 39 .protected \name 40 .align \size 41 .size \name , \size 42 \name : 43 .org .+\size 44.endm 45 /* The base address (relative to enclave start) of the heap area */ 46 globvar HEAP_BASE 8 47 /* The heap size in bytes */ 48 globvar HEAP_SIZE 8 49 /* Value of the RELA entry in the dynamic table */ 50 globvar RELA 8 51 /* Value of the RELACOUNT entry in the dynamic table */ 52 globvar RELACOUNT 8 53 /* The enclave size in bytes */ 54 globvar ENCLAVE_SIZE 8 55 /* The base address (relative to enclave start) of the enclave configuration area */ 56 globvar CFGDATA_BASE 8 57 /* Non-zero if debugging is enabled, zero otherwise */ 58 globvar DEBUG 1 59 /* The base address (relative to enclave start) of the enclave text section */ 60 globvar TEXT_BASE 8 61 /* The size in bytes of enclacve text section */ 62 globvar TEXT_SIZE 8 63 /* The base address (relative to enclave start) of the enclave EH_FRM_HDR section */ 64 globvar EH_FRM_HDR_BASE 8 65 /* The size in bytes of enclacve EH_FRM_HDR section */ 66 globvar EH_FRM_HDR_SIZE 8 67 68.org .Lxsave_clear+512 69.Lxsave_header: 70 .int 0, 0 /* XSTATE_BV */ 71 .int 0, 0 /* XCOMP_BV */ 72 .org .+48 /* reserved bits */ 73 74.data 75.Laborted: 76 .byte 0 77 78/* TCS local storage section */ 79.equ tcsls_tos, 0x00 /* initialized by loader to *offset* from image base to TOS */ 80.equ tcsls_flags, 0x08 /* initialized by loader */ 81.equ tcsls_flag_secondary, 0 /* initialized by loader; 0 = standard TCS, 1 = secondary TCS */ 82.equ tcsls_flag_init_once, 1 /* initialized by loader to 0 */ 83/* 14 unused bits */ 84.equ tcsls_user_fcw, 0x0a 85.equ tcsls_user_mxcsr, 0x0c 86.equ tcsls_last_rsp, 0x10 /* initialized by loader to 0 */ 87.equ tcsls_panic_last_rsp, 0x18 /* initialized by loader to 0 */ 88.equ tcsls_debug_panic_buf_ptr, 0x20 /* initialized by loader to 0 */ 89.equ tcsls_user_rsp, 0x28 90.equ tcsls_user_retip, 0x30 91.equ tcsls_user_rbp, 0x38 92.equ tcsls_user_r12, 0x40 93.equ tcsls_user_r13, 0x48 94.equ tcsls_user_r14, 0x50 95.equ tcsls_user_r15, 0x58 96.equ tcsls_tls_ptr, 0x60 97.equ tcsls_tcs_addr, 0x68 98 99.macro load_tcsls_flag_secondary_bool reg:req comments:vararg 100 .ifne tcsls_flag_secondary /* to convert to a bool, must be the first bit */ 101 .abort 102 .endif 103 mov $(1<<tcsls_flag_secondary),%e\reg 104 and %gs:tcsls_flags,%\reg 105.endm 106 107.text 108.global sgx_entry 109.type sgx_entry,function 110sgx_entry: 111/* save user registers */ 112 mov %rcx,%gs:tcsls_user_retip 113 mov %rsp,%gs:tcsls_user_rsp 114 mov %rbp,%gs:tcsls_user_rbp 115 mov %r12,%gs:tcsls_user_r12 116 mov %r13,%gs:tcsls_user_r13 117 mov %r14,%gs:tcsls_user_r14 118 mov %r15,%gs:tcsls_user_r15 119 mov %rbx,%gs:tcsls_tcs_addr 120 stmxcsr %gs:tcsls_user_mxcsr 121 fnstcw %gs:tcsls_user_fcw 122 123/* reset user state */ 124/* - DF flag: x86-64 ABI requires DF to be unset at function entry/exit */ 125/* - AC flag: AEX on misaligned memory accesses leaks side channel info */ 126 pushfq 127 andq $~0x40400, (%rsp) 128 popfq 129 130/* check for debug buffer pointer */ 131 testb $0xff,DEBUG(%rip) 132 jz .Lskip_debug_init 133 mov %r10,%gs:tcsls_debug_panic_buf_ptr 134.Lskip_debug_init: 135/* check for abort */ 136 bt $0,.Laborted(%rip) 137 jc .Lreentry_panic 138/* check if returning from usercall */ 139 mov %gs:tcsls_last_rsp,%r11 140 test %r11,%r11 141 jnz .Lusercall_ret 142/* setup stack */ 143 mov %gs:tcsls_tos,%rsp /* initially, RSP is not set to the correct value */ 144 /* here. This is fixed below under "adjust stack". */ 145/* check for thread init */ 146 bts $tcsls_flag_init_once,%gs:tcsls_flags 147 jc .Lskip_init 148/* adjust stack */ 149 lea IMAGE_BASE(%rip),%rax 150 add %rax,%rsp 151 mov %rsp,%gs:tcsls_tos 152/* call tcs_init */ 153/* store caller-saved registers in callee-saved registers */ 154 mov %rdi,%rbx 155 mov %rsi,%r12 156 mov %rdx,%r13 157 mov %r8,%r14 158 mov %r9,%r15 159 load_tcsls_flag_secondary_bool di /* RDI = tcs_init() argument: secondary: bool */ 160 call tcs_init 161/* reload caller-saved registers */ 162 mov %rbx,%rdi 163 mov %r12,%rsi 164 mov %r13,%rdx 165 mov %r14,%r8 166 mov %r15,%r9 167.Lskip_init: 168/* call into main entry point */ 169 load_tcsls_flag_secondary_bool cx /* RCX = entry() argument: secondary: bool */ 170 call entry /* RDI, RSI, RDX, R8, R9 passed in from userspace */ 171 mov %rax,%rsi /* RSI = return value */ 172 /* NOP: mov %rdx,%rdx */ /* RDX = return value */ 173 xor %rdi,%rdi /* RDI = normal exit */ 174.Lexit: 175/* clear general purpose register state */ 176 /* RAX overwritten by ENCLU */ 177 /* RBX set later */ 178 /* RCX overwritten by ENCLU */ 179 /* RDX contains return value */ 180 /* RSP set later */ 181 /* RBP set later */ 182 /* RDI contains exit mode */ 183 /* RSI contains return value */ 184 xor %r8,%r8 185 xor %r9,%r9 186 xor %r10,%r10 187 xor %r11,%r11 188 /* R12 ~ R15 set by sgx_exit */ 189.Lsgx_exit: 190/* clear extended register state */ 191 mov %rdx, %rcx /* save RDX */ 192 mov $-1, %rax 193 mov %rax, %rdx 194 xrstor .Lxsave_clear(%rip) 195 mov %rcx, %rdx /* restore RDX */ 196/* clear flags */ 197 pushq $0 198 popfq 199/* restore user registers */ 200 mov %gs:tcsls_user_r12,%r12 201 mov %gs:tcsls_user_r13,%r13 202 mov %gs:tcsls_user_r14,%r14 203 mov %gs:tcsls_user_r15,%r15 204 mov %gs:tcsls_user_retip,%rbx 205 mov %gs:tcsls_user_rsp,%rsp 206 mov %gs:tcsls_user_rbp,%rbp 207 fldcw %gs:tcsls_user_fcw 208 ldmxcsr %gs:tcsls_user_mxcsr 209/* exit enclave */ 210 mov $0x4,%eax /* EEXIT */ 211 enclu 212/* end sgx_entry */ 213 214.Lreentry_panic: 215 orq $8,%rsp 216 jmp abort_reentry 217 218/* This *MUST* be called with 6 parameters, otherwise register information */ 219/* might leak! */ 220.global usercall 221usercall: 222 test %rcx,%rcx /* check `abort` function argument */ 223 jnz .Lusercall_abort /* abort is set, jump to abort code (unlikely forward conditional) */ 224 jmp .Lusercall_save_state /* non-aborting usercall */ 225.Lusercall_abort: 226/* set aborted bit */ 227 movb $1,.Laborted(%rip) 228/* save registers in DEBUG mode, so that debugger can reconstruct the stack */ 229 testb $0xff,DEBUG(%rip) 230 jz .Lusercall_noreturn 231.Lusercall_save_state: 232/* save callee-saved state */ 233 push %r15 234 push %r14 235 push %r13 236 push %r12 237 push %rbp 238 push %rbx 239 sub $8, %rsp 240 fstcw 4(%rsp) 241 stmxcsr (%rsp) 242 movq %rsp,%gs:tcsls_last_rsp 243.Lusercall_noreturn: 244/* clear general purpose register state */ 245 /* RAX overwritten by ENCLU */ 246 /* RBX set by sgx_exit */ 247 /* RCX overwritten by ENCLU */ 248 /* RDX contains parameter */ 249 /* RSP set by sgx_exit */ 250 /* RBP set by sgx_exit */ 251 /* RDI contains parameter */ 252 /* RSI contains parameter */ 253 /* R8 contains parameter */ 254 /* R9 contains parameter */ 255 xor %r10,%r10 256 xor %r11,%r11 257 /* R12 ~ R15 set by sgx_exit */ 258/* extended registers/flags cleared by sgx_exit */ 259/* exit */ 260 jmp .Lsgx_exit 261.Lusercall_ret: 262 movq $0,%gs:tcsls_last_rsp 263/* restore callee-saved state, cf. "save" above */ 264 mov %r11,%rsp 265 ldmxcsr (%rsp) 266 fldcw 4(%rsp) 267 add $8, %rsp 268 pop %rbx 269 pop %rbp 270 pop %r12 271 pop %r13 272 pop %r14 273 pop %r15 274/* return */ 275 mov %rsi,%rax /* RAX = return value */ 276 /* NOP: mov %rdx,%rdx */ /* RDX = return value */ 277 ret 278 279/* 280The following functions need to be defined externally: 281``` 282// Called by entry code on re-entry after exit 283extern "C" fn abort_reentry() -> !; 284 285// Called once when a TCS is first entered 286extern "C" fn tcs_init(secondary: bool); 287 288// Standard TCS entrypoint 289extern "C" fn entry(p1: u64, p2: u64, p3: u64, secondary: bool, p4: u64, p5: u64) -> (u64, u64); 290``` 291*/ 292 293.global get_tcs_addr 294get_tcs_addr: 295 mov %gs:tcsls_tcs_addr,%rax 296 ret 297 298.global get_tls_ptr 299get_tls_ptr: 300 mov %gs:tcsls_tls_ptr,%rax 301 ret 302 303.global set_tls_ptr 304set_tls_ptr: 305 mov %rdi,%gs:tcsls_tls_ptr 306 ret 307 308.global take_debug_panic_buf_ptr 309take_debug_panic_buf_ptr: 310 xor %rax,%rax 311 xchg %gs:tcsls_debug_panic_buf_ptr,%rax 312 ret